Weil-McLain Gas Boiler Repairs, Installations & Maintenance

Weil-McLain Boiler Repairs

With our cold Canadian winters, residential boilers can take a beating especially during the winter months. Green Heating & Air provides 24/7 emergency boiler repairs. We have extensive experience with Weil-McLain Evergreen and WM97+ CT Wall Mount Gas Boiler. As well as other models from Weil-McLain.

Weil-McLain Boiler Installations & Replacements

Green Heating and Air, carries the Evergreen and WM97+ CT Wall Mount Gas Boiler. We have acccess to inventory and we can replace and install a Weil-McLain boiler for you. Our Certified Technicians can assess your situation and provide a free estimate for the cost of installing a new Weil-McLain boiler or a replacement.

We’ve installed the Weil-McLain Evergeen boiler as a single installation unit or in a multi-boiler environment. You can have it as a standard floor standing unit or wall mounted boiler (wall mount kit required). It’s powerful enough to be used for residential homes from heating your home to your swimming pool or for light commercial installations. We provide the highest quality of service from the installation to on-going maintenance. We follow industry best practices and we’re up to date on the newest technologies, latest models and makes.

Common Problems with Weil-McLain Boilers:

If you find that your boiler is giving you any one of these problems, contact Green Heating and Air immediately. It’s vital to schedule on going maintenace to ensure your boiler runs optimally. If you are experiencing:

• Leaks and Dripping: Water leaks can originate from failing gaskets, corroded pipes or boiler sections, faulty pump seals, or a malfunctioning pressure relief valve.
• No Heat or Hot Water: This can be due to a malfunctioning thermostat, failed components (like the circulator pump, gas valve, or ignition system), low water levels/pressure, or air in the system.
• Ignition Problems / Pilot Light Issues: Your pilot light might be going out and not staying lit (often due to a faulty thermocouple, especially in older models), problems with the electronic ignition module, or a dirty/faulty flame sensor. Gas supply problems can also prevent ignition.
• Pressure Issues (Low or High): Boilers may shut down if the water pressure is too low. Conversely, excessive pressure can cause the pressure relief valve to discharge water. Causes include system leaks, a faulty pressure reducing valve (fill valve), issues with the expansion tank (waterlogged or faulty), or air in the system.
• Strange Noises:
  1. Kettling (Rumbling/Banging): Can be caused by limescale or sludge buildup within the heat exchanger, restricting water flow and causing localized boiling.
  2. Gurgling/Whistling: Can indicate air trapped within the system (radiators may need bleeding), low water pressure, or issues with the circulator pump.
  3. Ticking: Continuous clicking noise.
• Condensate Pipe Problems: For high-efficiency condensing boilers, the condensate drain pipe can freeze in cold weather, causing a blockage and system shutdown.
• Component Failures: Specific parts can fail over time, including the circulator pump, gas valve, pressure relief valve, various sensors (temperature, pressure), the control board (PCB), or the aquastat (limit control).
• Needing Frequent Resets: If the boiler frequently requires manual resetting (often via a button on the aquastat or control module), it usually indicates an underlying fault condition, such as overheating or a sensor issue, that is causing a safety lockout.